WIFI Signal Scanner 2.4-inch TFT Color Display 2.4G/5G WIFI Signal Usage Analyzer Router Management Assistant

• weight: 485 g

Description:
In the same environment, there are too many wifi signals, multiple signals occupy the same frequency point, and affect each other, which will cause the quality of your own wifi signal to be poor. Using this assistant, you can easily check which frequency point has more signals. If the frequency point is relatively free, you can adjust your own wifi, switch the frequency point to a relatively empty frequency point, and improve the communication quality of your own wifi.

Function:
1. Display the battery level in the upper right corner of the screen.
2. Built-in 600mAh lithium battery, the working current is about 160mA, and the standby time is about 4 hours.
3. Built-in lithium battery charging management circuit. The charging time is about 2 hours.
4. Use TYPE-C interface to charge, very convenient
5. The charging voltage is 5V. When charging, the red light means charging, and the green light means fully charged
6. 2.4-inch TFT color display.

Instructions:
1. Long press the button to power on, long press again to power off
2. Press the button once to start scanning, press the button again to suspend scanning
3. The waveform on the top of the screen shows all the wifi signals in the 2.4G frequency band. Originally, only the wifi signal with the strongest signal is displayed. However, if there are multiple signals at the same frequency point, they will be displayed in numbers below the corresponding coordinate scale. For example, if the number 5 is displayed, it means that the same frequency point is occupied by 5 wifi. The waveform below the screen corresponds to the waveform of the 5G signal. The interpretation method is the same as above. Since there are more frequency points of 5G signals, there is no way to mark all the frequency points on the coordinate scale.

Package Included:
1 x host
1 x TYPEC charging cable