Matek Systems ELRS-R24-P6 R24-P6 ExpressLRS 2.4GHz PWM Receiver With Antenna Support 2~8S VBat Voltage Sense For FPV RC Racing Drone

• weight: 485 g

Matek Systems ELRS-R24-P6 R24-P6 ExpressLRS 2.4GHz PWM Receiver With Antenna Support 2~8S VBat Voltage Sense For FPV RC Racing Drone

Description:

Brand: Matek Systems

Model: ELRS-R24-P6

Item: PWM Receiver

ESP8285, SX1281

Antenna connector: IPEX MHF 1

6x PWM outputs

Support 2~8S VBat voltage sense

RF Frequency: 2.4GHz (2400~2480MHz)

Telemetry power: 12dbm

Receiver output protocol: PWM

Input voltage: 4~9V DC @ “+” pad

Voltage sense: 34V Max. @ “VBat” pad

Power dissipation: 45mA(binding), 85mA(wifi mode)

PCB size: 20mm x 18mm

Weight: 2g w/ antenna

Firmwares

* ExpressLRS 3.0 or newer, DIY 2.4GHz / DIY 2400 RX PWMP EX.

* ExpressLRS wiki for PWM receiver, Click HERE

* Make sure Receiver and TX module both are running ExpressLRS 3.0 or newer.

——————————————————-

* Receiver has ExpressLRS 3.0 preloaded with binding phrase '123456', the Receiver will never enter binding mode if using the traditional binding procedure.

* You need to reflash it with your binding phrase OR go into WebUI to set your binding phrase.

Flashing via Wifi

* Disconnect ESC and servos from receiver first.

* Power on receiver by 5V source. Receiver's LED(Red) will blink slow at first, and after 20s, it should blink fast indicating it's on Wifi Hotspot Mode.

* More detailed steps, pls refer this page.

* Target: DIY 2.4 GHz / DIY 2400 RX PWMP EX.

Flashing via UART

* Disconnect ESC and servos from receiver first.

* Wire the receiver into the USB-TTL adapter, with TX on receiver connected to the Rx on the USB-TTL, and RX on receiver connected to the Tx of the USB-TTL. Wire 5V and GND of the USB-TTL to 5V and GND of the Receiver.

* Press the boot button while powering on the receiver, then release – the Red LED on receiver should now be solid.

* Select the target DIY 2.4 GHz / DIY 2400 RX PWMP EX and “UART” for Flashing Method, set your bind phrase and Firmware Options and once done, click on Build and Flash.

Package Included:

1x Matek Systems ELRS-R24-P6 Receiver

1x IPEX MHF1 Antennas. 15cm

Dupont 2.54 pins (Board is shipped unsoldered)