LILYGO® TTGO T-Display ESP32 CH9102F WiFi bluetooth Module 1.14 Inch LCD Development Board

Good delivery, well packed. Not yet tested

Well packaged, received in good condition and excellent delivery time (16 calendar days from order). I use a lot of esp32 variants in my various projects, so much so, that I try to always keep a good selection of the main variants in stock in my hobbyist electronics lab. The T-display has a nice compact form factor and is one of my favorites for early prototypes. ( Once I firm up on ideas in later prototypes, I'll usually switch to a generic ESP32 and a custom display selected according to requirements)

Well packaged and received in good condition but delivery time a bit slow (54 calendar days from order).

non funziona, arrivato con largo anticipo ma non va purtroppo

Well packaged, received in good condition and excellent delivery time (12 calendar days from order). This esp32 comes with a built-in LCD and a custom shell. It is a useful addition to my hobbyist electronics lab.

Well packaged and excellent delivery time (12 calendar days from order). The ESP32 remains one of the best all-round micro-controllers with comprehensive IO and good performance. The built in LCD of the t-display makes it ready to use for many projects I am happy to recommend this board.

Well packaged and reasonable delivery time (16 calendar days from order). The ESP32 is one of the best all-round micro-controllers with good performance and capable IO. This board adds an LCD display which makes it a useful module to keep in stock. I am happy to recommend it.

The best ESP32 board for prototyping out there. It is reasonably priced (especially considering the 16MB flash and USB-C port), nicely manufactured, has a battery charger circuit and even a decent documentation on github. The screen is about as big as possible to fit on a breadboard-friendly device, and even if you don't use it for your application, it comes in handy for debugging. TFT-eSPI supports the LCD out-of-the-box (Setup25_TTGO_T_Display.h), so it is just as easy to output text onto it as using Serial.print. Speaking of debugging, the only issue with this board is that GPIO14 is used for battery switching, therefore not accessible via a pad. This means that JTAG debugging requires some light modding (my preferred solution is to solder a wire from the diode on GPIO14 to the neighboring GPIO27 trace, but connecting a bodge wire from the diode directly to the ESP-PROG is also an option). Did I mention that it has not one but two on-board GPIO buttons, and the reset is nicely tucked away on the side? That alone makes it an instant get.

Доставка около месяца. Упаковка хорошая.

ok :-)