RadioMaster T8 Lite V2 2.4GHz 8CH CC2500 D8 D16 V1 Protocol Potentiometer Sensor Gimbal USB-C Charging Radio Transmitter for RC Drone

• weight: 485 g

RadioMaster T8 Lite V2 2.4GHz 8CH CC2500 D8 D16 V1 Protocol Potentiometer Sensor Gimbal USB-C Charging Radio Transmitter for RC Drone

Description: (Manual)

Brand Name: RadioMaster

Item Name: T8 Lite V2 Transmitter

Model: T8 Lite V2

Mode: Mode1/Mode2

Size: 160*130*45mm

Weight: 218g

Frequency: 2.400GHZ-2.480GHZ

RF Module: CC2500

Protocol Options: D8/D16 V1

Transmission power: 20dbm

Antenna gain: 2db

Range: > 1km @ 20dbm (depending on the receiver)

Battery: Built in 3.7v 1000mah Lithium battery

Charging: Built in USB-C charging

Firmware: Independent development system

Channels: Up to 8 channels (depending on the model / receiver)

Gimbal: High-precision quad bearing potentiometer sensor gimbal

*Does not support OpenTX

Bind mode for D8 protocol receivers:

1. Turn on the transmitter and keep the throttle at its lowest position. Press and hold the bind button for longer than 1 second, the transmitter will start beeping in a beep-beep-beep pattern, signaling D8 mode. If the transmitter beeps in a beep（x2）-beep(x2)-beep(x2) pattern, this means the transmitter is in D16 mode and the bind button should be pressed momentarily to return to D8 mode.

2. Power on the receiver, press the bind button on the receiver within 3 seconds to enter bind mode on the receiver.

3. The red light on the receiver will flash, signaling that the unit has bound successfully. Turn the receiver off and on again for the unit to function correctly.

Bind mode for D16 protocol receivers:

1. Turn on the transmitter and keep the throttle at its lowest position. Press and hold the bind button for longer than 1 second, the transmitter will start beeping in a beep(x2)-beep(x2)-beep(x2) pattern, signaling D16 mode. If the transmitter beeps in a beep-beep-beep pattern, this means the transmitter is in D8 mode and the bind button should be pressed momentarily to return to D16 mode.

2. Power on the receiver, press the bind button on the receiver within 3 seconds to enter bind mode on the receiver.

3. The red light on the receiver will flash, signaling that the unit has bound successfully. Turn the receiver off and on again for the unit to function correctly.

Package Included: (Optional Mode)

1 x T8 Lite V2 Transmitter