Original RadioMaster CNC Metal Upgrade Set Replacement Parts for TX16S Transmitter

Product is good quality. The installation could be challenging but there are some nice Youtube tutorials that makes it easier. Unfortunately I could not fit the 2 rocker panels.

really nice product. Obviously, there is no impact to the performance of the radio, but aesthetic side is much much better now. Now the radio looks like a "A league" player. However, you must be prepared for complete disassembling of the radio. it is stated in every review on youtube etc., so do not underestimate this effort. There are several guidance in internet, which can be useful for this procedure. I like personally this one: https://www.youtube.com/watch?v=DjP_gxObyfs BTW, by dissembling radio I spotted several under-tightened screws, so it was also a good change to fix it. Another issues was a broken vibration motor retainer. it seems that during the assembly on a factory, two screws were very tightened by someone and the plastic fixing element broke in half, so I had to use a bit of superglue. However, I would also like to add that for their money, TX16S is a very good radio.

tout simplement j'adore . attention pour le montage il faut quand même bien démonté l'intérieur .un peu cher quand même pour un accessoire.

とても格好良いです。 MDLボタンの加工が少し必要です。

top item ,very happy

very nice

90% there but the 10% that sucks is a big deal! READ THIS! the 4 little buttons are different and are metal and inside is shaped different and comes with a different board and buttons hard 2 push&wor

Waited for over 2 months, but worth the wait. Beautiful finishing and fits perfectly.

Finishing quality (machinig and anodizing) is meticulous. However, as for the function and fitment: - The 4 buttons on the lower left side are a bit shallower/flusher to the body. I liked the old ones better since it was sticking out a bit more, was easier to use. - Gibmal and spacers a bit flimsy to install, a better chamfer or fitting would be nice. The provided screws semm almost a bit to short. - Provided M3 hex screws are the same lenght as the original ones and are 2mm to long. I had to shorten 2 of them (for the grabhandle) an put 2 washers under the srew for the neckstrap holder. - The grabhandle scrapes or grinds againts the 2 miniature balls whith allow it to snap in place.

Top